John Deere 450g w/ripper Dozer

ENGINE 450G

Type..............................John Deere 4045T with altitude
                                      compensating turbocharger
                                      (direct drive only)
Rated power .................70 SAE net hp (52 kW) gross hp
                                   (54.5 kW) @ 2,100 rpm gross hp
Drawbar........................51 hp (38 kW)
Cylinders ......................4
Displacement ................276 cu. in. (4.524 L)
Fuel consumption, typical ....1.5 to 2.3 gal./hr. 
Maximum net torque.....228 lb.-ft. (309 Nm) @ 1,300 rpm
Lubrication.....................pressure system with full-flow spin-pressure system
Air cleaner ....................dual stage dry type, with safety element, pre-cleaner,  under-hood restriction indicator 
Electrical system.............12 volt with 65-amp alternator
Cooling fan ....................blower

TRANSMISSION 
full power shift, Dura-Shift with torque converter or direct drive; change gears easily using the engine decelerator 
and power shift
Maximum travel speeds
1st Forward ...............................2.30 (3.70)
2nd Forward .............................3.31 (5.33)
3rd Forward ..............................4.11 (6.61)
4th Forward ..............................5.91 (9.51)
1st Reverse ................................2.50 (4.02)
2nd Reverse...............................3.58 (5.76)
3rd Reverse................................4.47 (7.19)
4th Reverse ...............................5.93 (9.54)

FINAL DRIVES large heavy-duty final drive assemblies attach directly to the transverse case and are isolated from the track frame to keep final drives from being adversely affected by shock loads; 450G is single reduction

STEERING/BRAKES oil-cooled and modulated steering system; multiple wet-disk steering clutch

(A) Overall height with ROPS and cab
108 in. (2740 mm) 109 in. (2770 mm) 110 in. (2794 mm)
Overall height with lowprofile
ROPS.......................103.3 in. (2624 mm) 104.3 in. (2649 mm) 105.3 in. (2675 mm)
(B) Overall length Standard and wide tracks .....154.2 in. (3917 mm) 160 in. (4070 mm) 160 in. (4070 mm)
(B') Overall length Long and low ground pressure tracks 156.5 in. (3975 mm) 160 in. (4070 mm) 160 in. (4070 mm)
(C) Blade lift height.......................32.1 in. (815 mm) 34.1 in. (866 mm) 35.7 in. (906 mm)
(D) Digging depth .........................19.9 in. (504 mm) 18.1 in. (460 mm) 16.5 in. (420 mm)
(E) Blade cutting edge angle, two position adjustable .....50 or 55 degrees 50 or 55 degrees 50 or 55 degrees